Your use of this website is your acceptance of these terms and conditions of use.2.7 (7 votes). Such posts should, however, be reported to an Administrator for review. In addition, no claim is made that posts made here will be free from profanity, obscenity, rude, hurtful, libelous or insulting opinions of the poster. I can be reached at 3, or emailed at even Facebook THANKYOU.Īs such, each reader should not rely on any information available here as accurate and should independently verify such accuracy. I will be using the same old windows 98 computer to run the Roland, that I was using the Gerber on. I was hoping someone out there might be able to help me get er running I would be most appreciative. It has a serial port and a parrallel port, but no USB port (its too old). I am thinkng that since I own a CAS-Mate 6.52 key, I might as well use it if possible. The replacement, a Roland-24 is seemingly in mint condition, so I think I will be able to get some extended use out of it. Jim, you can setup CASmate to run on either LPT 1 or 2, or COMM 1 or 2. If you listed some of the paticulars of what your using such as Operating system. Maybe Im missing something here but I thought Casmate would only plot from a com port. If it is set to the wrong one you then need to go into your bios and set it there. My CASmate program is set-up on LPT1, which is the required port according to Scanvec.īolander you need to go into device manager and see if the port is set to ecp or epp. I never worker with add-on comm ports but i would think there is a section in the devices menu to set certain parameters.
It sets the communication speed and singlebidirectional data transfer. Now im not a computer tech But from what i learned over the years with my plotter and Flexi (i used Casmate a long long time ago) The port settings in the motherboard should be set at ECP.
0 kommentar(er)
